Corrugated Storage Install – Corrugated Polycarbonate

Design & Install Guide          Hardware        Corrugated Pricing        Quote & Order

Store in dry, shaded, vented area. Sloped stacking best. Store sheets in covered areas,  not under PVC coverings.
Sheet Orientation Warning: One side of sheet has protective U.V. surface, this surface must face to exterior. Sheet covered with plastic film and marked exterior. Prior to install peel film off sheet.
Cutting: Circular saw with plywood blade or jig saw with fine tooth blade. Clamp to avoid vibration. Leave film on sheet until ready to install.
Sheet Positioning: Install polycarbonate sheets with corrugated ribs running vertically on walls, and with slope on the roof.
Sheet Install: Refer to Links below for a description of sheet installation.
Overlap: Overlap of 1 corrugation recommended and yields an overall coverage of 48″. If an overlap is needed in the sheet length, we recommend a 4″ overlap. Do not apply sealants between overlapping panels, as this will cause unsightly dirt streaks.
Procedure: Begin by installing roof sheet. Wall sheets installed butt against roof panels. Use horizontal closures as specified in Closure Usage Drawing page. Sheet metal flashing is installed after sheet is in place. Corner Trim may be used, see Layout Close-up.
Attachment: Fasten screws and washers as shown in Details. Predrill with 1/4″ bit to allow for expansion. See Screw Layout and Installation Notes to determine screw count.
Cleaning: Clean with warm, soapy water. If dirt remains wipe with soft cloth. Do not scrub, scrape or use solvents. Rinse and dry with soft cloth.

Layout and Load Information             Layout Close-up             Sheet Joining             Ridge Details
Screw Layout             Closure Usage Drawing             Quonset Install             Install Notes

Also See 8-25mm Polycarbonate  and  Base and Cap Install System for Multiwall Polycarbonate

Polycarbonate Greenhouse and Sunroom Building Supplies