Polycarbonate Installation System – Aluminum “Base and Cap” for MultiWall

                          • View Frame Type Info Below For Your Structure:
Frame Type A:   Roof Purlins or Wall Girt See Layout & Load & Bend Radius          OR >
Frame Type B:   Frames with Vertical Rafters & Posts, See Layout & Load Support
Next see  Base & Cap Install Details Always Print details specific to your project.
Finally Print:  Frame Guide  &  Install Guide – After Frame Type & Install Details Reviewed

Min. roof pitch 5 degrees or 1/12 pitch                Info Sheet                Polycarbonate Hardware                     Questions

No leaks With No  Gaskets         No Vent Tape         Install Policy            Flashing Intro          Material List

Medium Bronze Painted         24 ft. @ $70 ea.         16 ft. @ $50 ea.         8 ft. @ $25 ea.      For  8,10,16,25mm
Clear Satin Anodized                24 ft. @ $85 ea.         16 ft. @ $60 ea.          8 ft. @ $30 ea.     For  8, 16 & 25mm
Mill Finish                                        24 ft. @ $55 ea.          16 ft. @ $40 ea.          8 ft. @ $20 ea.     For 8, 10 & 16mm

                                                        Colors and Trim Components

       Base & Cap cut as needed (for your poly sheets) and placed in crate, with poly & hdwr.

BaseCap Close Up.

Base & Cap FAQ’s       Plastic Trim Problems        Samples & Guide
$75 min. ship cost for 16′ & 24′ Base & Cap applies if we ship in 24′ lengths or cut and put in crate.

Note: Mid Sheet Beauty Cap can simply be used to cover mid rafter, simply Cap Only

Polycarbonate Greenhouse and Sunroom Building Supplies