Trim Installation Notes:-  

Select Poly-- -Samples & Guide -- Install Details -

-

Sheet Closure: Use U-Profile to close the lower edge of roof sheet and top of wall sheet Eave Detail and the Lower Edge of side wall sheets of freestanding greenhouses and front wall of lean-to greenhouses. Lean-To Ridge & Freestanding Ridge roof sheets and end wall sheets (See Roof Corner) must have aluminum tape at upper edge. This procedure will eliminate the possible entrance of dust, dirt and insects into the sheet channels. When U-Profile is used at lower edge of wall sheets and lower edge of roof sheets, a 1/16" weep hole is required, every 12" along the lower edge of the U-Profile, for moisture release.

-

Narrow Profile Cap: Used to join sheets, see Sheet Joining and Framing Layout.

-

Corner Trim: Polycarbonate sheet may have to be site cut to achieve a square corner. Corner Trim covers and protects Roof and Wall corners.

-

Ridge Flashing: Polycarbonate is set in place prior to installation of Lean-To Flashing or Freestanding Ridge Flashing. Flashing to be purchased locally.

-

See Framing Guide & Install Manual --Reading guides crucial for successful install.

-

Reload Sundance Supply Site