Lean-To Ridge-Base Cap Cost-Tech Info--- Screw counting for screws purchased separately

• If slipping poly. under eave put alum. tape on upper edge of poly. and slide under the eave.

We do not provide flashing - See Ridge Flashing Purchase & Install Intro In high wind areas use Sikaflex 295 UV, instead of silicone, to effectively bond tip of Ridge Flashing to polycarbonate.

-3" or 6" x 100 ft. Adhesive Roll Flashing Tape (shown below) has 15 mil Butyl Adhesive (facing down) and an Aluminum backing (that faces the sun). Make sure polycarbonate is securely fastened to the structure with the screws we sell. To purchase see Hardware Section of Online Order Form. See tech & install data sheet.

Drawing shows install on roof purlin. If using rafters a beveled ledger board required.

• Trim & Hdwr---• See Frame & Install Guides in Adobe Acrobat.

• Frames with horizontal roof purlins or wall girts, see Layout & Load & Bending.

• Rafters & posts, see Layout & Load Support and blocking placement ..

-

Reload Site