- Lean-To Ridge----We do not provide flashing - See
Ridge Flashing Purchase & Install
- --------
- --
-Cap Only Intro & Cost Page --------Screw
counting Cap Only
System
- e-
- If poly going under an existing
eave, out
of the weather, place
alum. tape on upper edge of the
poly
and
slide under the eave. In high wind areas use Sikaflex 295 UV, instead of silicone, to effectively bond tip of Ridge Flashing to polycarbonate.
- -3" or 6" x 100 ft. Adhesive Roll Flashing (shown below)
has 15 mil Butyl Adhesive (facing down) and Aluminum backing
(that faces the sun). Make
sure polycarbonate is securely fastened to structure with screws we sell. To purchase see Hardware
Section of Online Order Form. See tech & install data sheet
-
- Framing
Guide & Install
Manual Crucial read for successful
install
- .
- Reload
Site
-