- Corrugated - Screw Layout
- 2' On-Center Rafters &
Studs--->
Quote
& Order-------Reload
Site
-
- See Layout
for spacing of blocking. Also see Closure
Drawing.
- -
- • Wall Sheets: At top & bottom
& of wall sheets fasten to Top & Bottom Plates
with (1) 1" screw at every 3rd valley. In body of sheet fasten to Stud with (1) 2" wood or
(1) 1-1/2" self-drill metal screw every 36". At corners place a
2" wood or 1-1/2" self-drill metal screw every 12" on-center. See
Layout
Close-up.
- • Roof Sheets:
In body of sheet fasten to Rafter with (1) 2" wood or
(1) 1-1/2" self-drill metal screw every 36". At top and bottom
of roof sheets place screws every 2nd corrugation crown. At
corners position a 2" wood or 1-1/2" self-drill metal screw
every 12" on-center. See Layout
Close-up.
- Note: On steep slopes
one may use 1" screws in the valley of sheet. Best in high wind
areas.
- • Sheet Overlaps
Use a 2" wood or 1-1/2" self-drill screw at crown of sheet
overlap, every 12".
- • To avoid sheet
deforming fasten screws without excessive tension.
- Reload
Site