Metal Bldg. Corrugated Store & Install --Corrugated Quote and Order

 

Storage: Store in dry, shaded, well ventilated area. Supported, sloped stacking best. Store sheets in covered areas, but not under flexible PVC coverings.

Sheet Orientation Warning: One side of sheet has protective U.V. surface, this surface must be facing to exterior. Sheets covered with plastic film and marked exterior side. Prior to install peel film off sheet.

Cutting: Circular saw with plywood blade or jig saw with fine tooth blade. Clamp to avoid vibration. Leave film on sheet until ready to install.

Sheet Positioning: Install polycarbonate sheets with corrugated ribs running vertically on walls, and with slope on the roof.

Sheet Install: Install in similar fashion as adjoining steel panels.

Overlap: Overlap of 1 corrugation recommended and yields an overall coverage of 36". If an overlap is needed in the sheet length, we recommend a 6" overlap. Pop Rivets may be used to achieve a even fitting and watertight joint. Position Pop Rivets every 12" along the overlap. Do not apply sealants between overlapping panels, as this will cause unsightly dirt streaks.

Procedure: Begin by installing roof sheet. Wall sheets installed butt against roof panels. Sheet metal flashing is installed after sheet is in place. Corner Trim may be used, see Hardware.

Horizontal Closures: See drawings to determine In & Out Quantity.

Attachment: Fasten screws snug. Do not over tighten. Predrill with 1/4" bit to allow for expansion. See Layout and Screw Positioning Guidelines.

 

Cleaning: Clean with warm, soapy water. If any dirt remains wipe with soft cloth. Do not scrub, scrape or use solvents. Rinse and dry with soft cloth. 

 

 

Reload Sundance Supply Site