- Corrugated Storage &
Install --Corrugated
Quoting and Ordering
-
- Storage: Store in dry,
shaded, well ventilated area. Supported, sloped stacking best.
Store sheets in covered areas, but not under flexible PVC
coverings.
- Sheet Orientation
Warning: One side of sheet has protective U.V. surface, this
surface must face to exterior. Sheet covered with plastic film and
marked exterior. Prior to install peel film off sheet.
- Cutting: Circular saw
with plywood blade or jig saw with fine tooth blade. Clamp to
avoid vibration. Leave film on sheet until ready to
install.
- Sheet Positioning:
Install polycarbonate sheets with corrugated ribs running
vertically on walls, and with slope on the roof.
- Sheet Install: Refer
to Links below at bullets " • " for a description of sheet
installation.
- Overlap: Overlap of 1
corrugation recommended and yields an overall coverage of 48". If
an overlap is needed in the sheet length, we recommend a 6"
overlap. Pop Rivets may be used to achieve a even fitting and
watertight joint. Position Pop Rivets every 12" along the overlap.
Do not apply sealants between overlapping panels, as this will
cause unsightly dirt streaks.
- Procedure: Begin by
installing roof sheet. Wall sheets installed butt against roof
panels. Use horizontal closures as specified in various drawings.
Sheet metal flashing is installed after sheet is in place. Corner
Trim may be used, see Layout
Close-up.
- Attachment: Fasten
screws and washers as shown in Details. Predrill with 1/4" bit to
allow for expansion. See Screw
Layout and notes
Installation
Notes to determine
screw count.
- Cleaning: Clean with
warm, soapy water. If dirt remains wipe with soft cloth. Do not
scrub, scrape or use solvents. Rinse and dry with soft
cloth.
-
-
- Corrugated
Quoting and Ordering
Also
Also Steel
Truss Frames Covered with polycarbonate
-
- Reload
Sundance Supply Site
-
-
-