- Plans
have material lists, with screw quantities for Cap Only ( & Trim )
System.
- Back
to Cap Only Intro Page.
-
- Basics:
-
- Place one screw
every 12" along Cap & Corner face (Cap requires 9 screws,
Corner 18).
- .
Also place screws every 12" along perimeter of roof & walls, Details show screw placement.
-
- Screws also used at
mid-sheet.
-
-
- Roof -
- -•
Use 1 screw per foot along the top edge of roof slope. Set screw
through ridge flashing and into blocking
below.
- -•
Use 1 screw per foot along the lower edge of sheet, position
between Cap.
- -•
Aluminum Corner Trim (use 1 screw 2" from ends and every 12" along
each leg of Corner).
- Walls-
- -•
Aluminum Corner Trim (use 1 screw 2" from ends and every 12" along
each leg of Corner).
- -•
On side or front walls, use 1 screw per foot along the top &
bottom edge of sheet, position between Cap. Screw goes
through sheet and into blocking or top & bottom
plates.
- -•
On gable ends, with Corner Trim at top of sheet, place 1 screw per
foot along the bottom edge of sheet, position between Cap. Screw goes through sheet and into blocking or bottom plates. See
above for screw placement in Corner Trim.
-
- Around
Doors, Fans, Shutters 1
screw every 12" around perimeter of these items as
needed.
-
- Specify wood, pressure treated wood, steel or aluminum frame when
ordering. Screws to hold on U-Profile also provided.
-
- If installation is in a hurricane zone See Structural Load for recommendations.
-
- -
- Purchase
Samples & Guide
- -